SquallLHeart

it's not much of the connection of the bulb in the socket itself being tight..

but moreso the blades of the bulb (the actual electrical connection) fitting in tight inside the harness's female side.

it's the proper size of the blades that pretty much determine the connection.

any electronic store should have this conductive grease. i bought a small syringe full of the MG one for about $10-15 and it'll last awhile... you don't need much.
http://www.mgchemicals.com/products/8463.html

Spect2K3

Cool. Looks good. And just put some of that on the male connector? Just like a little thin line on each side of each male connector?

SquallLHeart

whatever works

StevieSoFly

i did this i bought the light bulb grease at autozone it was right were the bulbs were.. i grease it up! i figured it wouldnt hurt so why not...