How to fab a mass air flow sensor flange on a custom intake?
#1
How to fab a mass air flow sensor flange on a custom intake?
I was just curious if anyone has made a custom intake....if so how did you fabricate the mass air flow flange....and if not what would be a good way to do that?
#2
Re: How to fab a mass air flow sensor flange on a custom int
Originally Posted by jaytizzle
I was just curious if anyone has made a custom intake....if so how did you fabricate the mass air flow flange....and if not what would be a good way to do that?
#3
You will probably have to check a search engine. When i was into mitsu. eclipses people were putting GM air flow meters on there cars. I know there is adapters out there. I think K&N makes some generic ones
#4
im actualy going to make mine with my die grinder and as for the custom intake i bouth it took like maybe 3 feet of straight pipe well not even that mutch lol and 2 mandrel bent u bends with a 5" radius and one 90 degree mandrel bent with a 5" radius
https://www.scionlife.com/forums/viewtopic.php?t=87180
if you want to check it out for insperation
https://www.scionlife.com/forums/viewtopic.php?t=87180
if you want to check it out for insperation
#5
I made mine from the L bend of a 96+ Mustang GT cold air intake and a hacked intake pipe that includes teh flange from a Corolla with VVT-I.
The bottom is a more recent picture with the loom to cover up ugly wires.
The bottom is a more recent picture with the loom to cover up ugly wires.
Thread
Thread Starter
Forum
Replies
Last Post
hotroddelux
Scion xA/xB 1st-Gen Drivetrain & Power
2
12-03-2014 11:33 PM