JSVH

when will these duels be available?

ashraf2500

how much did this set up cost, maybe get an aftermarket bumper cuz it looks cheap lol all cut

NJthunder5spd

perhaps a muffler such as this one from flow master could give you your single muffler dual outlet setup. looks to me as if it could fit. once i get my pipe bender for xmas maybe ill use my cousins car as a test dummy.




info here: Flowmaster


this setup would be pretty much similar to an aftermarket dual for a honda crx.

WeDriveScions

Thread from the dead....

There is so little room under there... and cutting the bumper isn't clean enough for me...

Besides... not really adding any power... just possibly some asthetics... possibly.

zer0

Thats pretty clean right there...

WeDriveScions

It's still CUT... with a kit, it'd be wonderful though...

Look at the clearance.... talk about scrape-ville in the rear... Yikes...

I do love the way that it's set up though... just wish the clearance wasn't an issue.

davedavetC

iTrader: (4)

lol clean freak....







thats a good thing haha

zer0

You can barely tell its cut, only reason we know, is because we're looking for it and we know our tC's. The average joe wouldnt notice. IMHO

Guest

Its going to have some tight curves. :D I'm not sure the flowmaster is going to sound good on the tC. I try to keep the flowmasters away from the import cars.

Sam_J84

i think it looks bad a**

BOXMAN

Hey Gabe hit me up about that exhaust we were talking about its not too late!!! BUMP

Guest

PM sent out, :D

flintmicamike

hey guess what i found. a bumper that will fit with a dual exaust cutout

http://www.extremedimensions.com/6058.html



i am defently going to get the dual exaust if i get this rear bumper.

xilver

looks nice

Acsilva84

great looking kit

trialsindude

Out of curiosity since some people tested our cars w/o the stock exhaust and it sounds good if i am not mistaken. I am not sure on the demensions but how about unbolting the stocker and do a little custom piping and bolting on a stock SRT-4 exhaust like this
http://cgi.ebay.com/ebaymotors/2004-...spagenameZWDVW

davedavetC

iTrader: (4)

dont think it would work. look where the piping goes, that one ends on the drivers side, ours is on the passengers side, maybe with some work but it would sounds like crap IMO

Guest

Just to let everyone know that we are now taking orders for the tC dual axle back set-up. If you want different tip, please let us know. The price of the tC dual axle back is $680.00 Shipped out to your door. Please leave room on the porch for this one, because its a huge box! :D

JSVH

what is involved in the install? how does one go about cutting the bumper?

Guest

You can use a pair of dikes to cut the bumper or a Dremal tool. Just make sure to trace out the bumper cut out first. :D