SR*S Cat-back exhaust? UPDATE: PICS AND VID ADDED!!
#25
Senior Member
SL Member
Thread Starter
iTrader: (8)
Join Date: Jul 2006
Location: El Paso, TX
Posts: 1,241
Originally Posted by bluaeon
wow! thats one loud exhaust!
oh yeah, your left backup light is busted.
oh yeah, your left backup light is busted.
#26
You will deff lose a little top end hp with the cat but it will be minimal and the little bit of back pressure will give you back a nice bump of low end TQ and the cat will help get rid of some of the rasp.
if i were you i would look into the AEROEXHAUST "AR20 or AR25" resonators(depending on the mid-pipes diameter).But looking at that mid-pipe you are going to have to cut it to pieces... the resonator it comes with is where the cat will go and to add another resonator you may have to make the mid-pipe into a one piece...
if i were you i would look into the AEROEXHAUST "AR20 or AR25" resonators(depending on the mid-pipes diameter).But looking at that mid-pipe you are going to have to cut it to pieces... the resonator it comes with is where the cat will go and to add another resonator you may have to make the mid-pipe into a one piece...
#28
I guess so, since there would be no sensor behind the cat.
usually its never recommended to put anything that creates turbulence in the exhaust in front of cats but like i said its prob because usually theres a O2 sensor behind them.
i guess the muffler shop will let you know for sure.
usually its never recommended to put anything that creates turbulence in the exhaust in front of cats but like i said its prob because usually theres a O2 sensor behind them.
i guess the muffler shop will let you know for sure.
#30
Try using some flat nosed pliers,grab the lip of the center tube on the silencer and pull straight out or slightly wiggle it side to side, you could also spray some wd40 on the outer edge of the exhaust tip BUT your exhaust might smoke for a while afterwards...
#34
OK I finally got it after hours of nothing. No matter what kind of silencer you have if it is stuck all u need is a METAL COAT HANGER. You brake it to where the hook is no longer there then u take one end and bend it down, stick that end into the open hole of the silencer. Keep sticking it in until it catches then pull your heart out.... CAUTION: You will fall back.
Thread
Thread Starter
Forum
Replies
Last Post
gyiu
Regional - Pacific South
12
02-20-2015 04:20 PM
carid
Exclusive Sponsored Sales
0
02-09-2015 01:49 PM
PTUNING
PPC: Engine / Drivetrain
3
12-11-2014 08:09 PM
Besk_one
Scion xA/xB 1st-Gen Drivetrain & Power
26
11-19-2003 09:57 PM