Hydra 2 step launch control vid.
#62
Aight I found these two wires right under the clutch pedal, so i assume these are the cruise control clutch switch, the black and yellow wire.. the harness comes with black and red wire, does it matter where i tap it or its is reversible?
and here's the diagram that comes with the harness, everything is all connected except Wire D that is supposed to go to pin B12 cannot be inserted since pin B12 on the hydra harness is being used, alternative to this or this wire on B12 will have to be tapped?
and here's the diagram that comes with the harness, everything is all connected except Wire D that is supposed to go to pin B12 cannot be inserted since pin B12 on the hydra harness is being used, alternative to this or this wire on B12 will have to be tapped?
#65
^^ got a problem man, i got a problem with the settings, on outputs PWM10> PWM 11 MAP> I couldnt get the Input X and Y changed to the right settings, I load the correct map but once its online it goes back to the old settings.. i tried to change it manually while Im online but I get an error something like violation setting is password protected! thats prolly why I get couldnt get it to work, Im still waiting for phil to respond.. otherwise I might be calling hydra support to unlock it
#66
well make sure when downloaded to ecu then pull key for 15sec. to make sure its loaded properly then upload and check it. if that doesn't work call hydra direct and give them your box number or send them your map and they can fix it same day.
the main thing to do is stay calm it will all work out.
the main thing to do is stay calm it will all work out.
#67
lol yeah.. i will need to call hydra to unlock it.. but yeah no luck i pulled the out the key for a long time but the map setting still wouldnt stay.. its cool though i wont be using it until i get my slicks, i was just excited to hear it.
#69
its the cruise controll clutch switch. unplug it and wire it to the clutch switch side. in other words your cruise won't work again but shouldnt be to hard. follow the clutch pedal up you'll see the harness and go from there
#70
Phil confirmed that my settings right but i think its my wiring.. What I did is tap the yellow and red wire on that harness, so its not how its supposed to be wired?
here's how the wire looks now
So that cruise control harness will have to remain unplugged? and the two wires from the hydra will go to each pin that clutch switch?
here's how the wire looks now
Originally Posted by mikescion
its the cruise controll clutch switch. unplug it and wire it to the clutch switch side. in other words your cruise won't work again but shouldnt be to hard. follow the clutch pedal up you'll see the harness and go from there
#74
Senior Member
SL Member
Scion Evolution
Thread Starter
Join Date: Feb 2005
Location: Motor City
Posts: 2,860
ok You need the wires on the Launch control line to be connected to the Cruise control harness. Doesnt matter which wire goes on which end. The plug the harness back into its spot.
If you dont understand what I'm saying PM me and I'll give you my number.
If you dont understand what I'm saying PM me and I'll give you my number.
Thread
Thread Starter
Forum
Replies
Last Post
Subaru86
Scion FR-S Suspension & Handling
0
07-31-2015 04:00 AM