intercooler install
#42
Originally Posted by Bryan06tC
Originally Posted by Mugetsu
Originally Posted by Bryan06tC
can't take out your MAF sensor... even if you were running a standalone ems.... get an intake pipe.... ATP turbo has one.... www.atpturbo.com
speed density...or is it MAP?
i was speaking to you Bryan, The AEM"standalone" and Hydra "standalone" allow you to switch to a speed density/MAP setup doing away with the MAF.
(318 TC is not using a MAF on his set up)
the AEM "EMS" does not offer this feature...that i know of
#43
Originally Posted by olaHalo
blackberry camera phone FTW!!!!!
same as phils, except homemade
i'm thinking of a 28X7X2.5 intercooler but i want to either go under the radiator or OVER the fakey vents like rxtc. avoiding having to trim the bumper too much if at all.
#45
Originally Posted by Mr_Meaty
he's got the same as me and I had no bumper trimming whatsoever.
Me? i didnt do it right lol.
i mounted the intercooler centered damn near perfect to the crazhbar; but it turns out the crashbar isnt centered perfectly on the car!
my sits a little ( youd never notice) to the left, and touchs right where the little clip attaches to the grill. so when i find a grill (someone through mine away) ill have to cut it maybe 1.4 inch to get it to fit properly
Thread
Thread Starter
Forum
Replies
Last Post
my06tc
PPC: Engine / Drivetrain
10
06-25-2015 12:18 AM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
12-02-2003 04:53 PM