My Scion.....340.6whp on 12 psi.....ran 12.4 quarter mile
#1
My Scion.....340.6whp on 12 psi.....ran 12.4 quarter mile
Yoo whats up everyone....as you know i have been rebuilding my car for a while now and its finally starting to come together.....im still waitting on a couple of things for my fuel step up but....i had my car tunned at 12 psi the other day and had a chance to bring it to the track....last weekend.....and ran some good numbers on low boost.....so here is the dyno sheet from last week....i will keep u guys updated as i keep getting more power :-D
#10
what tires were you on? and what rims?
im assuming you were on slicks, because its almost impossible to run a 12.4 at that hp in a tC without slicks.
either way, CONGRATS... thats really inspirational.
im assuming you were on slicks, because its almost impossible to run a 12.4 at that hp in a tC without slicks.
either way, CONGRATS... thats really inspirational.
#11
welll right now .....
New turbo
New fuel pump
rebuild motor
Pistons 8:5:1
Rods
Mains
Bearings
Shortblock machine assembly work
3 inch downpipe
electrical cut off valve
water/meth injection
Greddy Prefec Boost controller
Tial BOV 50mm
Greddy manifold
New piping
New intercooler
NOS Kit...still not finsh installing it
and more just cant think of everything right now
New turbo
New fuel pump
rebuild motor
Pistons 8:5:1
Rods
Mains
Bearings
Shortblock machine assembly work
3 inch downpipe
electrical cut off valve
water/meth injection
Greddy Prefec Boost controller
Tial BOV 50mm
Greddy manifold
New piping
New intercooler
NOS Kit...still not finsh installing it
and more just cant think of everything right now
#13
Originally Posted by Mightygnu
was that 12.4 with spraying, and what turbo are you using?
#20
Just out of curiousity are you using the water/meth injection? If so did it make any difference from a power standpoint?
Nice #'s by the way. You have another 20+ whp in your current set up ;) at the same psi level.
Regards-
Todd
Nice #'s by the way. You have another 20+ whp in your current set up ;) at the same psi level.
Regards-
Todd