""OFFICIAL"" Turbo 1/4 TIMESLIP THREAD
#1
""OFFICIAL"" Turbo 1/4 TIMESLIP THREAD
Post your time slip.. And all the info on it.. Post mods if you want..
ONLY TURBO-S/C
-------
TIME SLIP
Note what car you were
What TIRES
WHAT CLUTCH
Engine MODS
------
Videoif you have one!
ONLY TURBO-S/C
-------
TIME SLIP
Note what car you were
What TIRES
WHAT CLUTCH
Engine MODS
------
Videoif you have one!
#2
12.4 @ 111 1.807 60 FT
Mickey Thompson Drag Slicks 24.5x8x15
Clutch Masters Twin Disk Stage 7
Custom Turbo Kit 14PSI Stock Motor
http://www.youtube.com/watch?v=Sf9KS9Ftr2Y
Mickey Thompson Drag Slicks 24.5x8x15
Clutch Masters Twin Disk Stage 7
Custom Turbo Kit 14PSI Stock Motor
http://www.youtube.com/watch?v=Sf9KS9Ftr2Y
#3
Oh geeze.... Let me see about this one.
Can I just post up time slips? I don't remember all that I had done and whatnot for each run.
Houston Raceway Park = 1/4mile
Houston Motorsports Park = 1/8mile
I can say I've only ran the Turbonetics Kit @ 8.7psi (wastegated) on street tires w/1degree per 1psi retardation on the timing on each of these fun runs. I'll have more to post up when it starts cooling down here in Houston.
Can I just post up time slips? I don't remember all that I had done and whatnot for each run.
Houston Raceway Park = 1/4mile
Houston Motorsports Park = 1/8mile
I can say I've only ran the Turbonetics Kit @ 8.7psi (wastegated) on street tires w/1degree per 1psi retardation on the timing on each of these fun runs. I'll have more to post up when it starts cooling down here in Houston.
#4
^^ Wow, thats a lot of slips, lol!!!
heres my best run so far...
TRD S/c, Stock 7lb pulley, Forge 007 BPV, TRD drop-in filter, Injen Axle back, TRD Lowering springs (if they are helping at all), bald Falken tires, and stock Auto Trans w/ B&M Trans cooler. << i figure thats not too shabby for an auto.
heres my best run so far...
TRD S/c, Stock 7lb pulley, Forge 007 BPV, TRD drop-in filter, Injen Axle back, TRD Lowering springs (if they are helping at all), bald Falken tires, and stock Auto Trans w/ B&M Trans cooler. << i figure thats not too shabby for an auto.
#7
#12
With my auto turbo setup my best is 14.5 at 99.5 mph - that's on stock yokahama crappy ___ tires and around 7.5 psi Also it was 90*+ outside and 90%+ humidity Ill take a pic of the timeslip later and edit
Mod list -
Cast mani heat wrapped - all downpipe and wg dumptube custom fabbed by myself and heatwrapped
Tnetics Wastegate (38mm) - 7 psi spring installed - pretension set very high - actual boost 7.5-8 psi
T3/T61 turbo
Dezod FMIC and modified piping
HKS BOV
Biggggg ole tranny cooler
AEM FIC
Soon to come -
Better tires
Modified valve body for auto tranny
Mod list -
Cast mani heat wrapped - all downpipe and wg dumptube custom fabbed by myself and heatwrapped
Tnetics Wastegate (38mm) - 7 psi spring installed - pretension set very high - actual boost 7.5-8 psi
T3/T61 turbo
Dezod FMIC and modified piping
HKS BOV
Biggggg ole tranny cooler
AEM FIC
Soon to come -
Better tires
Modified valve body for auto tranny
#15
Im on the right. This slip was before I had my WOT Box, after my Wot box I was down to 9.0-9.1 in the 1/8 consistently. I was on 7psi, street tires, stock clutch, stock motor, full interior, custom kit. Man I miss those nights at the track
My fastest time ever was a 8.965 in the 1/8 but I haven't scanned that slip, I need to look for it.
My fastest time ever was a 8.965 in the 1/8 but I haven't scanned that slip, I need to look for it.
#20