JDMTC5

iTrader: (3)

So your the one with that heat shield lol. Nice.

Jbarker1983

iTrader: (1)

My dad custom last cut it here at work precision sheet metal
Shop

scion86

iTrader: (2)

Any noise coming from the pulley is not good. you should check the bearings. Just incase, be4 it gets worse. And cost more..

Jbarker1983

iTrader: (1)

If i take it apart how can i tell if the bearings are bad? do i need any special tools?

cmcpride

iTrader: (3)

have you notice that your belt is riding, off the edge of your lower idler bearing?

gompka

iTrader: (5)

Just need an allen wrench and a couple of sockets, the bearings will be nasty and you will see it. They will not spin very nicely, the may slide off the shaft, there should be metal shavings inside of the pulley housing.

Its hard to tell whats going on just from a video, but when mine went it sounded almost exactly like that.

Jbarker1983

iTrader: (1)

here is another vid after driving for a bit doesnt make the noise and appears spinning straight.

Jbarker1983

iTrader: (1)

can i install the bearings myself or need a special tool or something. im going to take the belt off and spin the pulley see if it resists.

gompka

iTrader: (5)

Once the shaft warms up the sound may stop, but I still think you have a bearing issue and should check it out.

Jbarker1983

iTrader: (1)

Do you sell the bearings ill need for that pulley? Also could the belt be to tight cause this noise?

Jbarker1983

iTrader: (1)

Hey if i got a used ecu w/o trd reflash can i use it? 2005-10 all fit or do i need 2010 model 5 spd?

JDMTC5

iTrader: (3)

Must be from 07-10 non reflashed and manual. Since yours is a 2010.

Jbarker1983

iTrader: (1)

Just wanted to makesure 07-10 is compatible

JAY_NYCE

If you follow Gompka instructions on his website to take off your shaft, you can take it to your local mechanic and have him press out your bearings for around 40 bucks. Thats how much I was quoted. You can get new bearings off ebay/amazon between 20 - 60 bucks {{6205LLBC3}}. If you don't have the cash, you can use "Bill me later" and get the bearings in a week. just pay off the bearings in time.

Jbarker1983

iTrader: (1)

Got a link to the pulley side bearings where to buy can't find them

gompka

iTrader: (5)

http://www.grainger.com/Grainger/NTN...-Bearing-6L027

scion86

iTrader: (2)

Never knew they had bearings that cheap for the s/c lol. How long will these last ? I thought the ceramic ones where better.

http://www.superchargedscions.com/5652.html

Jbarker1983

iTrader: (1)

Is there a temporary way to plug the oil Pan when I remove the s/c so I can still drive my car n/a till I fix it?

cmcpride

iTrader: (3)

no need ,, all you need to remove is the front shaft ,by removing it from the supercharger housing,

Jbarker1983

iTrader: (1)

So I can remove the whole shaft and when I'm driving oil won't ____ out everywhere??how doesn't that happen?