Sheet Metal Intake....
#22
you guys need to make two versions, one with the stock throttle body and one with the rx-8 throttle body. both would obviously need to be located in the stock location of the throttle body. that way high hp guys can run the rx-8 throttle since its bigger and plugs right in.
#23
Originally Posted by deathbyc4
you guys need to make two versions, one with the stock throttle body and one with the rx-8 throttle body. both would obviously need to be located in the stock location of the throttle body. that way high hp guys can run the rx-8 throttle since its bigger and plugs right in.
#25
Senior Member
SL Member
Scion Evolution
Originally Posted by krazylowgsx
it plugs right in? that doesn't seem right? if i'm going to run a bigger throttle body, i'm going to use an Accufab!
#26
Originally Posted by soros151
Originally Posted by krazylowgsx
it plugs right in? that doesn't seem right? if i'm going to run a bigger throttle body, i'm going to use an Accufab!
#29
Senior Member
SL Member
Scion Evolution
sorry, old thread here in SL, I was the test subject, but the TB I bought seemed to be bad, or stuck. I never could finish my N/A project, so I did the next thing to do. Move to Florida. :D
#31
Senior Member
SL Member
Scion Evolution
Thread
Thread Starter
Forum
Replies
Last Post
Sgtfluffy16
Regional - Northeast
3
07-28-2021 10:32 PM
rvascion
Maintenance & Car Care
6
11-12-2020 03:23 AM
rain7905643
PPC: Engine / Drivetrain
3
06-13-2018 05:29 AM