^lol, my photographer is my self with a point and shoot.

 

umad?

 

^^My photographer's from Sears.

@Irishguy0224, do you prefer those fog lights over VRD/APTs?

 

Im kind of uncertain about them tbh, a lot of people said they like the looks of them...But i think i want APT/VRD fogs just because i want to... idk im all wishy washy about them. haha. I think i just want clear lenses again honestly so imma need new fogs again.

To those of you with tucked tires, hows your turn radius now?

 

hotchkis springs / trd struts

225/35/19X8.5 35 offset. tuckeds

I rub a little on the driver front and cut the rear fenders but the turn radius is fine.

 

 

^ Woot. SBC RPF1s own alll!!!!!!1

 

yes jasper, we do own all!!! (unless some volks or ccw's come creeping along) lol, j/k

I'll match ur side profile shot

 

Rolled my fenders tonight with my buddy. Tomorrow my fender liners are coming out and moar low will be had.

 

Ok, so i need HELLPPPP

Rolled my fenders last night and then dropped my car another 1.5"... Still have threads left on my coils. However, now instead of rubbing on the fenders i am rubbing on the bolt connector for the bumper and fender... What the hell do i do to stop this?! Helpppppp

 

Cut the fender lip and remove the bolt

 

how do i keep the fender together then?

 

The edge of the fender is loose but looks and works fine

 

Alright, the b!tch is getting cut off. I'm assuming you have done the same?

 

I just loosely added a zip tie for additional support. Just in case. My tire hits the bumper often so I like having something hold it in place.

 

 

^ What are those?

 

Yeah I have cut on mine

Both my bumpers are held on with zip ties. Actually about 1/4 of my car is held together with zip ties

 

Where would you zip tie it though? i am rubbing on the part that screws the bumped to my fender. If i cut it off, there will be nowhere to zip tie

 

I just got the rears cut last weekend. The part of the bumper that points at the tire is loose right now. I can pull it out a little bit. But it looks fine and is staying in place.

I am going to take the tires off and use a rubber coating to cover the edge that was cut to protect against rust and then I'm gonna figure out how to secure it better. I'm thinking that I'll just drill some little holes for the zip ties.