TRD Quickshifter
#62
Though.... the instructions mention a "large" flathead screwdriver, it did help.
and I totally agree the TRD SS is an awesome mod. Tempted to do the same on my xB1 but it drives like a truck.
#63
#68
Well I finally had the chance to install it.
Installation was very easy once you take the air filter housing out and you'll see the two locations to install the extender and the quickshifter itself (see pics below). All it did was move the cable up and sideways by maybe 1 inch and that there made the BIG difference!
You'll notice it when you shift. It is for sure a shorter throw. At first I thought I was in neutral when it was actually in 1st gear. The stick shift bearly moves and took me few shifts to get aquainted. Overall... great mod, the short throw shifts is worth it.
Installation was very easy once you take the air filter housing out and you'll see the two locations to install the extender and the quickshifter itself (see pics below). All it did was move the cable up and sideways by maybe 1 inch and that there made the BIG difference!
You'll notice it when you shift. It is for sure a shorter throw. At first I thought I was in neutral when it was actually in 1st gear. The stick shift bearly moves and took me few shifts to get aquainted. Overall... great mod, the short throw shifts is worth it.
#71
Ok so I think the stealership is trying to dick me I am up here for my 5000 mole service and I thought I would ask how much they would charge to put it in they said probably like 1 and 1/2 hours worth of labor is there any way to verify how much this should cost me?
#73
#77
Just had my TRD SS installed and am also hearing this, also hearing a really awkward noise when i drive the car past 120km/hr not really sure how to describe it, but I had the part installed at the stealership maybe they messed something up?
#78
I just installed my quick shifter yesterday and it is amazing... especially since i didnt have to replace my shifter. as far as the clunking noise you are all concerned about, my car clunks going into 1st and 2nd before and after install. its just how our transmission sounds. have a buddy shift your car through the gears while you look under the hood to see what all takes place when shifting gears. it will be louder than you think.
#80
Grab the largest flat head screw driver, put the point against the bent part of the U-clip, hold the handle with your left hand, and use your right hand to pull up. The first time you remove that U-clip it is a beast.