Project Zelas...In Search Of The Emblem That Fits
#1
Project Zelas...In Search Of The Emblem That Fits
Alright It's 2am in NH and I'm bored. So I took off the front emblem to make measurements and see what it looks like.
Measurements:
Width = 4 7/8(12.4cm)
Height = 3 5/16(8.4cm)
Luckily, my mother drives a Toyota Rav4 2005 so I debaged it
It did not have the black backing and did not really fit. It popped out a second after I took the pic
Conclusion:
2005 Rav4 doesnt work (Unless brute force is used of course)
....Keep looking
Measurements:
Width = 4 7/8(12.4cm)
Height = 3 5/16(8.4cm)
Luckily, my mother drives a Toyota Rav4 2005 so I debaged it
It did not have the black backing and did not really fit. It popped out a second after I took the pic
Conclusion:
2005 Rav4 doesnt work (Unless brute force is used of course)
....Keep looking
Last edited by Scion202; 06-08-2011 at 07:09 AM.
#3
so kinda hard to tell since i dont want to break my mother's emblem.
#5
#7
#9
#11
as i mentioned, it could work with brute force. i'll take a look at it again today while the sun is up however the rav4 badge seemed a little too big so it may not fully fit in the cut out even after its glued to the black backing.....may have to file the edges
#13
it's not about recognition here, just ideas out loud and more ways to make the car your own. I'd rather have no badges at all but the front leaves no choice. I'm completely removing the rear one and filling in the holes and the indent
#16
#19