saifulreza108

Im going to istall the apex'i safc unit tomorrow.....I'll be posting pics soon, u said u got the book on how to tune engine management system ? that's great!
and vito .... is your turbo bolt-ons? or custom made ?

saifulreza108

great job vito.....nice .....very nice...

Simplyscion

Its bolt on turbo, but the only pieces i used from the kit was the manifold, turbo and intercooler, and as for the fuel setup, i pieced that together.

saifulreza108

https://www.scionlife.com/gallery/sh...cat/500/page/1
[img][/img]

saifulreza108

installed it today......haven't dyno it yet though coz the dyno is fully booked for tuning other cars for this august drag race.....

https://www.scionlife.com/gallery/sh...cat/500/page/1


[img][/img]

Simplyscion

what are you driving?? A righthand drive something...it dont look like no xB, or xA...is it an echo?

saifulreza108

No vito it's not an echo,xa/xb either bro ! its a toyota vios but toyota is using the same 1nz engine , and yeah right hand drive....fully bodykitted , manufactured in thailand , I'll post the pics of it later . Even got a turbo model in thailand developed by TRD but is only limited , if I'm not mistaken for only about 700 units.

Simplyscion

Thats sweet
Send some pics

saifulreza108

https://www.scionlife.com/gallery/member.php?uid=19505[img][/img]

saifulreza108

vito...can the 1zz injectors fit in the 1nz without regrinding the injector holes ? what injectors and fuel pump do u use ? can I use the 1zz celica fuel pump instead ?

Simplyscion

Yea I think the 1zz injectors fit. Im using the 2zz injectors and they definitely work fine. As far as the fuel pump goes, im using a Walbro 255LPH(definitely overkill cause the in tank regulator will only allow about 45-55 psi through.) I dont know if a celica pump would work but I would think so cause if I got the 255 LPH pump to fit you could fit anything smaller than that w/ no problem. We had to mess w/ the retainer clips in order for it too work but it is running fine w/ no problems so far. We basically just cut the clip in half between the regulator and the pump, grinded down the regulator part till it clipped in on 2 sides and tossed the fuel pump clip cause the pump is secure in the tank and wont get pushed out of the sending unit cause it has no where to go.

saifulreza108

where can I get them injectors and fuel pump online ? any suggestions ? The one's that can ship them goodies to Borneo of course !

Simplyscion

Try hooking up w/ Power Enterprise directly cause all of their stuff ships directly from Japan...they have a fuel pump and injectors that are a direct fit for the 1nz-fe