HID's with glare shield or paint...
#1
HID's with glare shield or paint...
Hello everyone,
i was wondering if anyone had hid installed and to control the beam from shooting anywhere, they made their own glare shield or paint the bulb?
is there any info on the web for this?
thanks!
i was wondering if anyone had hid installed and to control the beam from shooting anywhere, they made their own glare shield or paint the bulb?
is there any info on the web for this?
thanks!
#2
Easiest way would be to get a pair of casper shields (for H4 housings only) and run a set of D2S or D2R bulbs in them from a HID conversion kit (like the one I sponsor!) I don't have this setup installed yet but am going to test in the near future..I ordered a set of the shields when they come in I'll let you know. Alot of folks have the same question you do so I figured I'll give them a try and see what the difference is between shields and no shields..
Thread
Thread Starter
Forum
Replies
Last Post
SloTC1
PPC: Engine / Drivetrain
14
08-16-2018 02:45 PM
Guilles_Tc
Scion tC 2G Aero & Exterior
1
10-15-2015 03:09 AM
bulb, casper, ceramic, conversion, copnversion, d2s, difference, diy, glare, glareshield, h4, hid, paint, painted, shield, shields, shrouds