Luminics Bulbs/ harness Question
#21
Originally Posted by PRE5TON
I just got the harness and it was very easy to install. Cut the existing harness off, strip some wire, and strip some off of the replacement harness, and either use a tap, or twist tie and electrical tape it. It took me about 20 minutes to do both of them.
#23
So you're saying you have it wired to the original harness? The point of getting a new one was to replace the old one. Cutting, stripping, and soldering the 2 wires together is the best procedure in replacing a wiring harness and will work just as good as the original. You may want to use heat shrink tube to protect the exposed wire too.
#27
So for those people that splice into their oem harness and put a "beefier" harness on the end, what about the original wires? Wouldn't they be too thin to handle the load? What's the point of attaching thicker wires with a better plastic clip on the end if the crappy wires you attach them to could get too hot and get fried? I don't get it.
Thread
Thread Starter
Forum
Replies
Last Post