Then you won't have to do all that cutting.

 

but the cutting is so much fun. its the putting it all back together that sucks.

 

still can, smaller wheels, and if hes getting a kit anyway, easier to be on the ground too

 

the only way that box could go lower is if it got smashed. god forbid.


ain't nothing lower than that

 

well here's a slammed xB on full HKS coilovers...the pics don't do it justice, but if you guys were to ever see this car in person, you'll definitely see how low it really is...





PHAZE 2...go low or go home [/img]

 

It's very nice, but nowhere near as low as Randy's.

 

didnt say it was...

plus..Randy's is on bags...coilovers can't go as low as bags

 

I love the way this car looks but look how messed up the front lip is.

 

It wouldn't matter if you threw the smallest wheels and tires you could find on the box. Even the lowest bolt on air suspension will not go as low as Randy. To get that low takes some serious cutting. As shown in his description above.

Nothing wrong with a bolt on kit as long as you understand ahead of time that YOU WILL NOT LAY. (Oversized gaudy body and lip kits DO NOT count.)

 

RANDY GOTS IT.........

i think it looks like a brick sittin' on the floor....can't go any lower than that......
YOU DOING IT MAYNE...

 

lol, I want the bag setup so I can go over speed bumps, or the crappy roads around here, I've decided against coil overs because I need to be high enough up to go down the road cause our roads suck *****

 

David The photoshop looks nice. I think its time for you to bag yours now.... I need to send you a pic of mine so you can photoshop and make it look that low....lol. Love the way it looks

 

'bags cant even get as low as my 'bags.

 

the only way to go lower would be to cut the bottom of the car out and set just a set of wheels in the wells

 

someday i'm going to cut it at the doors, and put it on a minitruck chassis. rear wheel drive and all.

 

^^^^I believe it!^^^^

 

i say build a tubular front clip and make some 1 off control arms and some 1 off spindles to keep it fwd, then UNIBODY drop.

 

laying door on a 20/22 combo would be pretty clean, i would probably also sheetmetal the rear and do a wood floor with ss inserts in the rear

 

i bet if you ran some 14x6 with like some 165 60's or something tiny on there. and remove the front sway , and um move teh fuel filler probably. maybe you'd be low. not as low as randode but you'd be damned low. just cheat and run 13 inch daytons with like positive 30 offset and 3 inch wide. haha

 

^^^that would look so bad.