Any tips on DIY fender rolling?
#1
Any tips on DIY fender rolling?
I've read about using a wooden baseball bat to do it, but I'm not too keen on using that method, lol. I was looking at the Eastwood fender roller on Ebay. Those DIY'ers that have done this, what was your method and what did you use? Thank you
#2
Not really a DIYer, I had a lot of help. I agree you should find a roller if at all possible. A roller has MUCH more control, and it's still a bit tricky. Then again, I've never tried the baseball bat method, so who knows?
Some stuff that might help prevent paint chips: Use a a razor to score the paint, so if the paint does chip, it will chip at the scored line. For more chip protection, cover the part that you will roll with tape
Oh and go slow. Also, roll the fender as flat as possible, so you won't have to do it again....
Hope that made sense...I'm a bit lightheaded on codeine
Some stuff that might help prevent paint chips: Use a a razor to score the paint, so if the paint does chip, it will chip at the scored line. For more chip protection, cover the part that you will roll with tape
Oh and go slow. Also, roll the fender as flat as possible, so you won't have to do it again....
Hope that made sense...I'm a bit lightheaded on codeine
Thread
Thread Starter
Forum
Replies
Last Post
Wrencher
Scion xB 1st-Gen Owners Lounge
1
07-29-2015 01:38 PM
tribe
Scion xA/xB 1st-Gen Suspension & Handling
2
07-25-2015 05:21 PM