JDM Bb badge installation
#1
JDM Bb badge installation
how do you install the front and the back Bb emblem???, do you just snap the scion emblem off then just pop the Bb emblem on? thats what i heard but i was just wondering if thats how simple it is cuz the scion emblem is round and the Bb one is square.
PS...
do you guys have any pictures of a camoflouge xB with Bb badges?
PS...
do you guys have any pictures of a camoflouge xB with Bb badges?
#2
I think Rockrawler has the bB badge on the front.
I don't have the emblem on mine, I have a billet grille, but I am sure it's just a matter of snapping one off and snapping another on one. Anyway, here is your pic you wanted... https://www.scionlife.com/gallery/sh...cat=500&page=1
I don't have the emblem on mine, I have a billet grille, but I am sure it's just a matter of snapping one off and snapping another on one. Anyway, here is your pic you wanted... https://www.scionlife.com/gallery/sh...cat=500&page=1
#3
the front grill emblem just snaps-on...if you take a look at the front grill, you'll see the emblem is just snapped on...the back, there's a "how-to" in the Tech section of this site on how to take the back emblem off...
JC
JC
#5
Pull the whole round part off the grille and you'll see the spot where it clicks right in. Leave it to Scion to try to stuff a round peg on a square hole...
For the rear badges, heat the glue with a heat gun or hair dryer or park in the sun and then use some dental flossto cut thru the mounting tape.
For the rear badges, heat the glue with a heat gun or hair dryer or park in the sun and then use some dental flossto cut thru the mounting tape.
Thread
Thread Starter
Forum
Replies
Last Post
randomsuper
Scion xB 2nd-Gen Aero & Exterior
6
12-05-2014 11:14 PM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
12-02-2003 04:53 PM
Besk_one
Scion xB 1st-Gen Aero & Exterior
1
10-30-2003 05:14 PM