drill bit sizes, millimeters converted to standard
08-20-2007 | 12:33 AM
#1
Thread Starter
Junior Member
Joined: Aug 2007
Posts: 5
drill bit sizes, millimeters converted to standard
Can somebody tell me what size drill bits to use since millimeters are impossible to find?
Cargo net I need a 3.5mm and a 10mm.
Rear spoiler I need 3mm, 8mm, and a 10mm.
Thanks
Cargo net I need a 3.5mm and a 10mm.
Rear spoiler I need 3mm, 8mm, and a 10mm.
Thanks
08-20-2007 | 01:31 AM
#2
Member
SL Member
Joined: Aug 2007
Posts: 77
From: Kearneysville, WV
I used the following for the cargo net:
25/64 = 9.92mm
9/64 = 3.57mm.
Both could have actually been slightly bigger. I would rather drill too small of a hole and have to enlarge, then the other way.
Good chart here: http://mdmetric.com/tech/cvtcht.htm
Dan
25/64 = 9.92mm
9/64 = 3.57mm.
Both could have actually been slightly bigger. I would rather drill too small of a hole and have to enlarge, then the other way.
Good chart here: http://mdmetric.com/tech/cvtcht.htm
Dan
Thread
Thread Starter
Forum
Replies
Last Post
rain7905643
Scion tC 1G Forced Induction
7
03-14-2015 12:48 AM
lunchbx05
PPC: Interior / Electronics
0
12-11-2014 06:13 PM
Genesis
Scion xB 1st-Gen Owners Lounge
64
01-22-2005 01:02 PM
arinvolvo
Scion xA/xB 1st-Gen Drivetrain & Power
1
01-21-2004 11:40 PM
