xD Ragtop Open & Randode's Sick A$$ Cube PICS
#1
xD Ragtop Open & Randode's Sick A$$ Cube PICS
Went over to Randy's house today with Scott so Randy could install some lowering springs on Scott's Mustang GT...While there, snapped some pics of the xD with the ragtop open and happened to get a few of Randy's sick a$$ Cube...Not the best quality pics because they were taken with my HTC thunderbolt but they will have to do...One day I will do a proper photoshoot of my ride...
Some interior shots...Hard to capture the headliner material...
Some interior shots...Hard to capture the headliner material...
#3
Yes the vinyl paint was super easy and dries pretty quick...Just remember, do several light coats until it's properly covered and not heavy coats...As far as the headliner, we used a spray gun and air compressor with Weldwood Contact Cement as the glue...Learned from past experience after many headliners not to use 3M 90m it stays for awhile and then will eventually sag...We did it the way it's done at an upholstery shop...You can get a cheap sprayer at Harbor Freight for cheap...
#5
Yep Apply evenly to both surfaces...Make sure the fabric you use has a backing so there is no bleed through...
And for reference for those that want to know what to use for painting interior pieces here is what the can looks like...Make sure you start with the bottom of each item you are painting and finish it before moving onto the top...Make sure each coat is dry (about 5-10 minutes) before applying each additional coat...I used flat black for mine...
And for reference for those that want to know what to use for painting interior pieces here is what the can looks like...Make sure you start with the bottom of each item you are painting and finish it before moving onto the top...Make sure each coat is dry (about 5-10 minutes) before applying each additional coat...I used flat black for mine...
Last edited by YELOSUB; 09-06-2011 at 01:58 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Flyfishfreak
PPC: Engine / Drivetrain
23
06-10-2016 02:55 AM